Angle reference for honing guide
Protrusion stop 2026-09-06 16.46.12.excalidraw
2026-09-10
- crosscut feet, ripped strip for stops
- want a bit of truing:
- base edges need to be flat and square for accurate measurements of stop depths and to register honing guide against
- base faces flat for glue (pretty good already though)
- feet need one flat face (pretty good already though, and don’t fuck up them currently being same thickness)
- stop strip needs at least one flat face (for glue) and square edge (for registering blade)
- bit of cleanup
2026-09-30
- cut stops
- trued up
- assembled and glued up!#ppp
- challenge: stops moving around while gluing pilot holes, lost a lot of precision
- maybe CA glue + activator would be better than screws here?
- challenge: accidentally planed off markings I’d thoughtfully put on the stops so I’d know which ones went with which pilot holes
- challenge: one stop split when screwing
- challenge: one screw turns freely in hole
